Re: [CAD_CAM_EDM_DRO] Re: Gecko Faults

kadeshan <kader@...> wrote:


I could only run a reduced setup on one axis, the other two need to
be direct drive. Looks like steppers might have to do it...Can you
run steppers with 320's?

/// No, 320's are for brush type DC servos only. Does the one axis with reduction run ok? If reduction is the issue, I'd find a way to use a reduction on the other two and stay with the servos.

Ron







---------------------------------
Do you Yahoo!?
Check out the new Yahoo! Front Page. www.yahoo.com/a

[Non-text portions of this message have been removed]