CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re:W.E.T.-EDM

Posted by TomP
on 2005-02-05 22:38:11 UTC
Bill,
I didnt know it was a tap burner
there's a special difference there
not quite like other edm
it cuts just as it bumps into part
then notices the short
then runs away
then repeats forever
the cutting only occurs during the brief correct gap position
not suitable for other kinds of edm
and the p/s is different too
some are just inexpensive welder dc supplies
again not suitable for other forms of edm
but the basic mechaninsm maybe workable
tomp


--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.300 / Virus Database: 265.8.5 - Release Date: 2/3/05

Discussion Thread

vulcom1 2005-02-02 09:56:55 UTC Software Question Thomas Powell 2005-02-02 10:07:21 UTC Re: [CAD_CAM_EDM_DRO] Software Question cnc_4_me 2005-02-02 10:19:04 UTC Re: Software Question Alan Marconett 2005-02-02 11:40:47 UTC Re: [CAD_CAM_EDM_DRO] Software Question Edwin C. Kraemer 2005-02-02 19:31:06 UTC RE: [CAD_CAM_EDM_DRO] Software Question TomP 2005-02-03 01:43:27 UTC Re: [CAD_CAM_EDM_DRO] Software Question vulcom1 2005-02-03 07:54:33 UTC Re: Software Question turbulatordude 2005-02-03 08:10:31 UTC Re: Software Question for EDM TomP 2005-02-03 08:57:42 UTC Re: [CAD_CAM_EDM_DRO] Re: Software Question TomP 2005-02-03 10:45:46 UTC Re: [CAD_CAM_EDM_DRO] Re: Software Question art 2005-02-03 15:30:52 UTC Re: [CAD_CAM_EDM_DRO] Software Question wthomas@g... 2005-02-05 09:43:04 UTC Re: [CAD_CAM_EDM_DRO] Re:W.E.T.-EDM TomP 2005-02-05 22:38:11 UTC Re: [CAD_CAM_EDM_DRO] Re:W.E.T.-EDM Victor A. Estes 2005-11-15 12:09:51 UTC Software Question Bill Johnson 2005-11-15 18:40:23 UTC Re: Software Question kz1927 2005-11-15 23:01:20 UTC Re: Software Question Victor A. Estes 2005-11-16 06:26:07 UTC Re: [CAD_CAM_EDM_DRO] Re: Software Question kz1927 2005-11-16 07:12:41 UTC Re: Software Question Jymmm 2005-11-16 15:42:04 UTC Re: Software Question kz1927 2005-11-16 16:16:07 UTC Re: Software Question kz1927 2005-11-16 18:21:35 UTC Re: Software Question