[CAD_CAM_EDM_DRO] Re: MircoStepping Drive Which One?

Yes I was planning on running twin leadscrews.
But I do have a questions about this ... that is,
would one of these motors be consider a Slave drive?
If so, then the

http://www.buildyouridea.com/hardware/arcsin/arcsin.html
driver (3 axes) would be able to be used?

Arcsin features:

* Ribbon cable connector for additional slave driver when 2 motors
are needed for a single axis.


Luke


turbulatordude wrote:

> Although the Xylotex is a decent drive it has it's limits to motor size.
>
> The HobbyCNC board is a 3 axis board, not sure why you want 4 axis
> with plasma unless you plan on running twin leadscrews.
>
>
>