Re: MircoStepping Drive Which One? Servo's

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Randy Wink" <rwwink@i...>
wrote:

> Just a question...
> If, instead of tossing the motor, I used it. Using a .200 lead

screw (5

> turns per inch) and turning it @ 500 RPM to get 100 inches per

minute, I'd

> need a 7.8:1 ratio between the motor and the screw to gear it down

to that

> speed full out. That would be a big multiplier for whatever

torque the

> motor could put out and also give me something like 1440 encoder

pulses per

> rev. Am I missing something in this?
> R. Wink

Be careful with that one (Item# 10-1834). I'm not too sure it has a
5v encoder. I seem to remember playing with one of those and never
did get the encoder working ( back when they had 500 or so in stock )

Fred Smith - IMService
htp://www.cadcamcadcam.com/hobby