Re: [CAD_CAM_EDM_DRO] CNC Sharline
Posted by
Rich D.
on 2000-06-21 19:55:50 UTC
Bil, et al,
Check the 'files' in the 'Sherline list' in egroups for some pics of my 5400 mill
mods using the 'wrong ends'.
Rich D.
wanliker@... wrote:
Check the 'files' in the 'Sherline list' in egroups for some pics of my 5400 mill
mods using the 'wrong ends'.
Rich D.
wanliker@... wrote:
>
> In a message dated 6/21/00 8:27:41 PM Mountain Daylight Time, KM6VV@...
> writes:
>
> << Stepper motors have *NO*
> tailshafts, so you loose the handwheels. >>
>
> Look at Ron Ginger's homepage, you can mount the X motor on the left end, the
> Y axis out the back, and use belt drive to the Z axis, and also get more
> torque, for the Z axis. This way you can use single ended shaft steppers, and
> still retain the handwheels. I also like the fact that the
> stepper/handwheels are at opposite ends, and are not as awkward as when they
> are on the same end.
> bill
Discussion Thread
Jon Anderson
2000-06-21 17:36:51 UTC
Re: [CAD_CAM_EDM_DRO] CNC Sharline
Alan Marconett KM6VV
2000-06-21 19:15:31 UTC
Re: [CAD_CAM_EDM_DRO] CNC Sharline
wanliker@a...
2000-06-21 19:47:12 UTC
Re: [CAD_CAM_EDM_DRO] CNC Sharline
Rich D.
2000-06-21 19:55:50 UTC
Re: [CAD_CAM_EDM_DRO] CNC Sharline
Alan Marconett KM6VV
2000-06-23 12:34:06 UTC
Re: [CAD_CAM_EDM_DRO] CNC Sharline
wanliker@a...
2000-06-23 12:39:22 UTC
Re: [CAD_CAM_EDM_DRO] CNC Sharline
Rich D.
2000-06-23 15:09:43 UTC
Re: [CAD_CAM_EDM_DRO] CNC Sharline
Alan Marconett KM6VV
2000-06-23 15:33:38 UTC
Re: [CAD_CAM_EDM_DRO] CNC Sharline
Darrell
2000-06-23 21:52:54 UTC
Re: [CAD_CAM_EDM_DRO] CNC Sharline
Peter Smith
2000-06-25 09:47:25 UTC
Re: [CAD_CAM_EDM_DRO] CNC Sharline
Spehro Pefhany
2000-06-25 10:03:21 UTC
Re: [CAD_CAM_EDM_DRO] CNC Sharline
Jon Elson
2000-06-25 22:37:08 UTC
Re: [CAD_CAM_EDM_DRO] CNC Sharline