Re: Newbie: Two halves of simple die not aligning properly - Long
Posted by
kaptainkarst
on 2005-08-19 19:09:10 UTC
I have found where the error is. However, I'm not sure how to correct
it. This will probably be a post for the Shoptask forum.
My X and Y tables are not traveling perpendicular to one another. I
can dial in one Axis and get it within .001 over 8" of travel but
then the other Axis is out by .02 over about half that distance!!
Thanks for the input.
I'm off to search the Shoptask forums....
it. This will probably be a post for the Shoptask forum.
My X and Y tables are not traveling perpendicular to one another. I
can dial in one Axis and get it within .001 over 8" of travel but
then the other Axis is out by .02 over about half that distance!!
Thanks for the input.
I'm off to search the Shoptask forums....
Discussion Thread
kaptainkarst
2005-08-19 00:09:31 UTC
Newbie: Two halves of simple die not aligning properly - Long
Marcus
2005-08-19 07:47:00 UTC
Re: [CAD_CAM_EDM_DRO] Newbie: Two halves of simple die not aligning properly - Long
Tom Hubin
2005-08-19 08:27:36 UTC
Re: [CAD_CAM_EDM_DRO] Newbie: Two halves of simple die not aligning properly - Long
Russ Waters
2005-08-19 09:04:06 UTC
Re: [CAD_CAM_EDM_DRO] Newbie: Two halves not aligning properly - Did you mirror......
Jon Elson
2005-08-19 09:53:01 UTC
Re: [CAD_CAM_EDM_DRO] Newbie: Two halves of simple die not aligning properly - Long
kaptainkarst
2005-08-19 15:33:14 UTC
Re: Newbie: Two halves not aligning properly : part 2...long again
ringleboy26
2005-08-19 16:21:48 UTC
Re: Newbie: Two halves of simple die not aligning properly - Long
Jon Elson
2005-08-19 19:08:35 UTC
Re: [CAD_CAM_EDM_DRO] Re: Newbie: Two halves not aligning properly : part 2...long again
kaptainkarst
2005-08-19 19:09:10 UTC
Re: Newbie: Two halves of simple die not aligning properly - Long
Tom Hubin
2005-08-19 22:54:32 UTC
Re: [CAD_CAM_EDM_DRO] Re: Newbie: Two halves of simple die not aligning properly - Long
kaptainkarst
2005-08-20 07:22:17 UTC
Re: Newbie: Two halves of simple die not aligning properly - Long
Jon Elson
2005-08-20 11:09:28 UTC
Re: [CAD_CAM_EDM_DRO] Re: Newbie: Two halves of simple die not aligning properly - Long
Jon Elson
2005-08-20 11:20:37 UTC
Re: [CAD_CAM_EDM_DRO] Re: Newbie: Two halves of simple die not aligning properly - Long
John Johnson
2005-08-24 06:26:41 UTC
Re: [CAD_CAM_EDM_DRO] Newbie: Two halves of simple die not aligning properly - Long