Re: [CAD_CAM_EDM_DRO] Re: dxf to gcode to Galil DMC software

The DMC-700 pdf. is 13mb would you like this emailed or do you have a
different preference before I send it?
Shawn

----- Original Message -----
From: "geostabilizer" <gmalone@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Monday, February 06, 2006 9:22 AM
Subject: [CAD_CAM_EDM_DRO] Re: dxf to gcode to Galil DMC software


> Hi Shawn,
> I checked galilmc.com and could not find any info on the 730
> controller. I suspect it is not a "bus-based" type. If it is the
> stand alone RS-232 type of interface my software should still be
> able to communicate with it using the Windows drivers however the
> real-time controller status may be too slow for the purpose of
> controller the laser. I would like to know more about this card. Do
> you have a pdf users manual you could email?
>
> Thanks, George
>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, shawncd@... wrote:
> >
> > Hi George,
> > I also have several stand alone DMC-730 three axis
> > controllers. These can be bought for very little money
> > on ebay. They are good controllers. I currently use
> > Galils old software "G Code to DMC" its ok, but its
> > not any where close to a comercial setup. If you like
> > I can send you a copy of the software. I could also
> > send you a 730 unit if you would like to play around
> > with it.
> > I have all of galils drivers for the 1000 series
> > controllers as well as the 730 so hopefully I can get
> > your software to comunicate with each.
> > I'm looking forward to testing your software.
> > I'll let you know how I come out.
> > Shawn
>
>
>
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...,
timg@...
> Moderator: pentam@... indigo_red@... davemucha@...
[Moderators]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this to be a
sister site to the CCED group, as many of the same members are there, for OT
subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM.
DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
> bill
> List Mom
> List Owner
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
>