RE: [CAD_CAM_EDM_DRO] milling circuit boards

Hi Bill,

The endmills you'll want to use for PCB milling are tiny! You'll want the
1/8" size.

Check out Eagle and PCB-GCODE lists. I just milled a 2nd TDOA RDF board
(Time Delay of Arrival, Radio Direction Finding) as a possible project for a
Ham Radio club my wife and I belong to.

Look at the DeWalt DW760 router with a 1/8" collet adapter.

Alan KM6VV

> [mailto:CAD_CAM_EDM_DRO@yahoogroups.com] On Behalf Of wdavis364
>
> Shopping around for a router, Some router have 1/4 collets and some
> have 1/4 collets and 1/8 collets. Not knowing much about this, what
> size collet will I would most likely to be using in milling circuit
> boards. Will 1/4 collets handle the very small size drill bits(1/32)?
> Thanks for any advice on this.
> bill