Re: ball screw preferences

Steve,

Thank you for the details. I've seen that technique (If I'm
understanding you correctly) of BL control used by Techno Isel in the
A/b nuts used in their routers and sold as parts. Always thought it
was an interesting approach. Wondered why it didn't see wider use.

With your endorsement here that will likely change,

Ballendo

>>B wrote:
>>P.S. Have you used these ballnuts?

>In CCED, Steve Blackmore <steve@...> wrote:
>Yes - I use them all the time, they are very good, and not that
>expensive. The nut has a split section where the ball track is and the
>adjusting screw actually squeezes it reducing the clearance. The screw
>they sell is rolled but it seems good quality with good hardening on
>the outer surface.