Re: [CAD_CAM_EDM_DRO] small cnc shop in northern colorado
Posted by
556RECON
on 2009-06-11 10:38:42 UTC
If you have a time table to move into the building, here is an
interesting note. When they had the new fire station built for the city
they were getting the concrete floors sealed. They ran into aproblem
where part of the sealent had to be removed and they were delayed in
moving into the building for 2 to 3 months. This caused a bunch of
problems because of the delays on moving equipment etc. I would make
sure the general contractor knows his stuff about this and not just go
for the cheapest deal.
OLD BOB
Roland Jollivet wrote:
interesting note. When they had the new fire station built for the city
they were getting the concrete floors sealed. They ran into aproblem
where part of the sealent had to be removed and they were delayed in
moving into the building for 2 to 3 months. This caused a bunch of
problems because of the delays on moving equipment etc. I would make
sure the general contractor knows his stuff about this and not just go
for the cheapest deal.
OLD BOB
Roland Jollivet wrote:
>
>
> I'm sure you are aware that there are hundreds of companies that will coat
> the floor, not unlike this one;
> http://www.chemcoat.com.au/profile.htm
> <http://www.chemcoat.com.au/profile.htm>
> I think contacting a few of them would be a preferrable source of
> information.
>
> Regards
> Roland
>
>
>
Discussion Thread
alexander samuel borsody
2009-06-11 07:13:31 UTC
small cnc shop in northern colorado
William Thomas
2009-06-11 09:13:22 UTC
Re: [CAD_CAM_EDM_DRO] small cnc shop in northern colorado
Roland Jollivet
2009-06-11 09:45:10 UTC
Re: [CAD_CAM_EDM_DRO] small cnc shop in northern colorado
556RECON
2009-06-11 10:38:42 UTC
Re: [CAD_CAM_EDM_DRO] small cnc shop in northern colorado
Danny Miller
2009-06-11 10:42:13 UTC
Re: [CAD_CAM_EDM_DRO] small cnc shop in northern colorado
William Bright
2009-06-11 12:09:32 UTC
Re: small cnc shop in northern colorado
Kis Mihaly
2009-06-11 12:27:50 UTC
Re: small cnc shop in northern colorado
Will Holding
2009-06-11 12:33:20 UTC
Re: [CAD_CAM_EDM_DRO] small cnc shop in northern colorado
Dave Halliday
2009-06-11 22:50:32 UTC
RE: [CAD_CAM_EDM_DRO] small cnc shop in northern colorado
Arnie Minear
2009-06-12 12:44:58 UTC
Re: small cnc shop in northern colorado
Alfredo Sola
2009-06-12 22:51:30 UTC
Re: [CAD_CAM_EDM_DRO] small cnc shop in northern colorado
Jon Elson
2009-06-13 08:20:32 UTC
Re: [CAD_CAM_EDM_DRO] small cnc shop in northern colorado
caudlet
2009-06-14 16:39:38 UTC
Re: small cnc shop in northern colorada [Partially off topic]
eric.hagedorn
2009-06-14 16:41:59 UTC
Re: small cnc shop in northern colorado [Off topic post]
Alfredo Sola
2009-06-18 20:05:36 UTC
Proxxon conversion