Re: [CAD_CAM_EDM_DRO] small cnc shop in northern colorado

Don't put a complicated pattern in. For example, the epoxy floor
coating comes with black and white flakes to texture it.

This make it hard to find a small dropped screw. Also hard to see dirt
or grease or puddles.

I'd recommend just a plain white.

Danny

556RECON wrote:

> If you have a time table to move into the building, here is an
> interesting note. When they had the new fire station built for the city
> they were getting the concrete floors sealed. They ran into aproblem
> where part of the sealent had to be removed and they were delayed in
> moving into the building for 2 to 3 months. This caused a bunch of
> problems because of the delays on moving equipment etc. I would make
> sure the general contractor knows his stuff about this and not just go
> for the cheapest deal.
>
> OLD BOB
>
> Roland Jollivet wrote:
>
>> I'm sure you are aware that there are hundreds of companies that will coat
>> the floor, not unlike this one;
>> http://www.chemcoat.com.au/profile.htm
>> <http://www.chemcoat.com.au/profile.htm>
>> I think contacting a few of them would be a preferrable source of
>> information.
>>
>> Regards
>> Roland
>>