Re: [CAD_CAM_EDM_DRO] Re:BEI encoder replacement
Posted by
Jon Elson
on 2010-10-10 10:58:10 UTC
Andrewdavid.mathison wrote:
sensitive to.
A white LED is not going to properly illuminate the sensor.
Jon
> Dear Dan MauchReally, you want an IR LED, that is what the silicon photodiode is most
>
> great post, very informative and saved a bundle in money...
>
> I was wondering if anyone ever tried using a suitable white LED (and dropper resistor) to replace the little lamp?
>
> It should give it an even better life, especially in an area of vibration (which is probably true), where filament lamps are a bit over sensitive......
>
sensitive to.
A white LED is not going to properly illuminate the sensor.
Jon
Discussion Thread
goslowjimbo
2010-10-09 11:51:32 UTC
BEI encoder replacement
Dan Mauch
2010-10-09 12:30:45 UTC
BEI encoder replacement
Danny Miller
2010-10-09 12:34:58 UTC
Re: [CAD_CAM_EDM_DRO] BEI encoder replacement
Jon Elson
2010-10-09 18:04:49 UTC
Re: [CAD_CAM_EDM_DRO] BEI encoder replacement
Andrewdavid.mathison
2010-10-10 06:33:11 UTC
Re:BEI encoder replacement
Dan Mauch
2010-10-10 07:22:54 UTC
Re:BEI encoder replacement
Jon Elson
2010-10-10 10:58:10 UTC
Re: [CAD_CAM_EDM_DRO] Re:BEI encoder replacement
Danny Miller
2010-10-10 11:01:18 UTC
Re: [CAD_CAM_EDM_DRO] Re:BEI encoder replacement
Andrewdavid.mathison
2010-10-11 08:23:04 UTC
Re:BEI encoder replacement
danmauch
2010-10-11 09:35:25 UTC
Re:BEI encoder replacement
Andy Wander
2010-10-11 10:30:38 UTC
RE: [CAD_CAM_EDM_DRO] Re:BEI encoder replacement
Tony Smith
2010-10-11 13:38:57 UTC
RE: [CAD_CAM_EDM_DRO] Re:BEI encoder replacement
Tony Smith
2010-10-11 13:46:42 UTC
RE: [CAD_CAM_EDM_DRO] Re:BEI encoder replacement
danmauch
2010-10-11 13:54:37 UTC
Re: BEI encoder replacement
James Reed
2010-10-11 16:39:19 UTC
RE: [CAD_CAM_EDM_DRO] Re: BEI encoder replacement
Roland Jollivet
2010-10-12 05:11:02 UTC
Re: [CAD_CAM_EDM_DRO] Re: BEI encoder replacement
Jon Elson
2010-10-12 09:49:02 UTC
Re: [CAD_CAM_EDM_DRO] Re: BEI encoder replacement
James Reed
2010-10-14 07:37:08 UTC
RE: [CAD_CAM_EDM_DRO] Re: BEI encoder replacement