Re: [CAD_CAM_EDM_DRO] Re: parallel port finally obsolete?

STEVE:

I am not sure if this will help you
https://www.probotix.com/pxb-usb_usb_interfaced_cnc_controller/

I bought one a while back and got side tracked with health problems. I
tested it and it worked good.
They have their own type of software to run it that you have to buy. I
will only work with their software that I know of.
They also have a cnc gppgle group that is helpful.

OLD BOB



scyvt wrote:

>
>
>
>
> Thanks everybody who replied to my original question.
>
> However I'm not sure that a central point of my query was noticed: I
> asked about USB-to-motor (stepper) driver hardware, not USB-to-BOB.
> (Ethernet would be OK too). So Smooth Stepper, for example, would not
> meet that requirement. I think Flashcut has one, but I believe it is
> dedicated to their whole system. Kflop might do that, but it doesn't
> seem suitable for beginners. Geckodrive attempted something
> incorporating this function and much more, but abandoned the project.
>
> Steve
>
>