Re: [CAD_CAM_EDM_DRO] single axis control
Posted by
jeremy youngs
on 2012-10-24 14:36:47 UTC
So what if it's overkill? Get a cheap PC, install Mach3, and away you go.
Andy Wander
linux is free as to the learning curve it is as easy to setup as mach with
stepconfig (added in version2.5) and very simple I would recommend a dual
core so as to be able to isolate the cpu, also lcnc can run in ladder mode
which would be a no brainer for this application. so one could keep his 375
if he had an old pc lying around, coupled with the fact its only runnung
one stepper i would say anything 486 or better will give satisfactory
results
--
jeremy youngs
[Non-text portions of this message have been removed]
Andy Wander
linux is free as to the learning curve it is as easy to setup as mach with
stepconfig (added in version2.5) and very simple I would recommend a dual
core so as to be able to isolate the cpu, also lcnc can run in ladder mode
which would be a no brainer for this application. so one could keep his 375
if he had an old pc lying around, coupled with the fact its only runnung
one stepper i would say anything 486 or better will give satisfactory
results
--
jeremy youngs
[Non-text portions of this message have been removed]
Discussion Thread
scyvt
2012-10-23 07:45:36 UTC
single axis control
Andy Wander
2012-10-23 07:57:29 UTC
RE: [CAD_CAM_EDM_DRO] single axis control
Roland Jollivet
2012-10-23 08:08:04 UTC
[CAD_CAM_EDM_DRO] single axis control
John Dammeyer
2012-10-23 09:21:12 UTC
RE: [CAD_CAM_EDM_DRO] single axis control
Roland Jollivet
2012-10-23 09:36:41 UTC
[CAD_CAM_EDM_DRO] single axis control
scyvt
2012-10-23 10:15:14 UTC
Re: single axis control
John Murphy
2012-10-23 11:03:29 UTC
Re: [CAD_CAM_EDM_DRO] single axis control
Rjreese29
2012-10-23 11:04:16 UTC
Re: [CAD_CAM_EDM_DRO] single axis control
Jeffrey Birt
2012-10-23 11:05:07 UTC
RE: [CAD_CAM_EDM_DRO] single axis control
John Dammeyer
2012-10-23 11:12:43 UTC
RE: [CAD_CAM_EDM_DRO] Re: single axis control
jeremy youngs
2012-10-23 13:45:40 UTC
Re: [CAD_CAM_EDM_DRO] Re: single axis control
jeremy youngs
2012-10-23 14:56:53 UTC
Re: [CAD_CAM_EDM_DRO] single axis control
David G. LeVine
2012-10-23 20:20:08 UTC
Re: [CAD_CAM_EDM_DRO] Re: single axis control
Roland Jollivet
2012-10-24 04:58:21 UTC
[CAD_CAM_EDM_DRO] single axis control
jeremy youngs
2012-10-24 14:36:47 UTC
Re: [CAD_CAM_EDM_DRO] single axis control