Re: [CAD_CAM_EDM_DRO] mach 3 software source

jon
thanx for correcting me and giving a better dissertation than i could have
on the matter

also im running an optiplex 620 and like it quite a bit, do you disable the
smi on yours and what latencies are you getting?

On Thu, Nov 15, 2012 at 11:49 PM, Jon Elson <elson@...> wrote:

> **
>
>
> jeremy youngs wrote:
> > gary do you have any experience with mach support? have you any
> experience
> > with lcnc support? just asking
> >
> I've been an EMC(xx) user since 1998, and have had great luck with it.
> Back in the
> beginning, you needed a TRUE guru, like the creators of the program at
> NIST,
> to get it running. Since then, it has gotten easier in steps, and is
> now VERY easy
> to install, and runs on most hardware. There have been problems with
>
--
jeremy youngs


[Non-text portions of this message have been removed]