Re: [CAD_CAM_EDM_DRO] Help: Machine Control Software Advice

Mike: I purchased cncpro and am pleased with it. I am new to cnc but am
busy making lots of chips. I had to jump in with both feet to get going
on a big job. So the learning curve has been short and not that
difficult. I use it on both my Bridgeport conversion and my lathe
conversion. I needed the ability to do peck drill cycles to do part of
the job and it fit that need. You might want to take a look at the
gcodes supported by each program to help make your decision. The full
cncpro is$175 and Doug promptly returned my emails.
Carey