Re: [CAD_CAM_EDM_DRO]doodling with ideas
Posted by
Anne Ogborn
on 2000-10-16 23:29:47 UTC
Alison & Jim Gregg wrote:
rifle stocks. Sears even sold one at one time.
>Yes, this device, a 'duplicator', is the normal way of making
> Hi All.
>
> There was an article in Engineering in Miniature a few years ago describing
> just this process being used at I think Woolwich Arsenal to "turn" complex
> shaped rifle stocks in wood. A similar process was used to make wooden
> pulley block housings for sailing ships.
>
> Jim Gregg.
rifle stocks. Sears even sold one at one time.
Discussion Thread
Joe Vicars
2000-10-16 08:17:07 UTC
Re: [CAD_CAM_EDM_DRO]doodling with ideas
Jon Anderson
2000-10-16 08:36:32 UTC
Re: [CAD_CAM_EDM_DRO]doodling with ideas
BillDarby
2000-10-16 08:50:13 UTC
Re: [CAD_CAM_EDM_DRO]doodling with ideas
dougrasmussen@c...
2000-10-16 09:09:14 UTC
Re: [CAD_CAM_EDM_DRO]doodling with ideas
BillDarby
2000-10-16 09:13:23 UTC
Re: [CAD_CAM_EDM_DRO]doodling with ideas
BillDarby
2000-10-16 09:22:16 UTC
Re: [CAD_CAM_EDM_DRO]doodling with ideas
Jon Anderson
2000-10-16 09:36:31 UTC
Re: [CAD_CAM_EDM_DRO]doodling with ideas
dougrasmussen@c...
2000-10-16 10:32:10 UTC
Re: [CAD_CAM_EDM_DRO]doodling with ideas
BillDarby
2000-10-16 11:00:14 UTC
Re: [CAD_CAM_EDM_DRO]doodling with ideas
Joe Vicars
2000-10-16 11:15:12 UTC
Re: [CAD_CAM_EDM_DRO]doodling with ideas
Jon Anderson
2000-10-16 11:40:18 UTC
Re: [CAD_CAM_EDM_DRO]doodling with ideas
BillDarby
2000-10-16 12:37:21 UTC
Re: [CAD_CAM_EDM_DRO]doodling with ideas
Ian Wright
2000-10-16 13:34:28 UTC
Re: [CAD_CAM_EDM_DRO]doodling with ideas
Alison & Jim Gregg
2000-10-16 19:18:11 UTC
Re: [CAD_CAM_EDM_DRO]doodling with ideas
ptengin@a...
2000-10-16 19:34:05 UTC
Re: [CAD_CAM_EDM_DRO]doodling with ideas
BillDarby
2000-10-16 20:00:33 UTC
Re: [CAD_CAM_EDM_DRO]doodling with ideas
Anne Ogborn
2000-10-16 23:29:47 UTC
Re: [CAD_CAM_EDM_DRO]doodling with ideas
R. T. Robbins
2000-10-22 20:43:36 UTC
Re: [CAD_CAM_EDM_DRO]doodling with ideas