Re: RE: Great deal on rotary encoders
Posted by
WAnliker@x...
on 1999-07-14 21:25:59 UTC
In a message dated 7/14/99 9:06:47 PM Pacific Daylight Time,
tkulaga@... writes:
<<
Will a 65000 limit be acceptable, or should I just say "damn the
torpedoes" and go for a limit in the billions?
metric leadscrew, if anyone is interested in changing them over.
bill
tkulaga@... writes:
<<
Will a 65000 limit be acceptable, or should I just say "damn the
torpedoes" and go for a limit in the billions?
>>I can't say about the numbers, but some of the small lathes have a very fine
metric leadscrew, if anyone is interested in changing them over.
bill
Discussion Thread
Tim Goldstein
1999-07-13 20:47:51 UTC
Great deal on rotary encoders
Dan Mauch
1999-07-14 06:58:53 UTC
Re: Great deal on rotary encoders
Tim Goldstein
1999-07-14 08:07:13 UTC
Re: Great deal on rotary encoders
Tim Goldstein
1999-07-14 16:49:32 UTC
RE: Great deal on rotary encoders
Dan Mauch
1999-07-14 19:53:53 UTC
Re: Great deal on rotary encoders
Tom Kulaga
1999-07-14 21:06:46 UTC
RE: Great deal on rotary encoders
WAnliker@x...
1999-07-14 21:25:59 UTC
Re: RE: Great deal on rotary encoders
Tim Goldstein
1999-07-14 22:14:18 UTC
RE: RE: Great deal on rotary encoders
Charles Gallo
1999-07-15 03:22:47 UTC
Re: RE: Great deal on rotary encoders
Dan Mauch
1999-07-15 06:35:52 UTC
Re: RE: Great deal on rotary encoders
Tim Goldstein
1999-07-15 08:31:54 UTC
Re: Great deal on rotary encoders
Matt Shaver
1999-07-15 08:37:35 UTC
Re: RE: Great deal on rotary encoders
Tom Kulaga
1999-07-16 18:39:31 UTC
Re: Great deal on rotary encoders
Dan Mauch
1999-07-17 07:20:28 UTC
Re: Re: Great deal on rotary encoders