Re: [CAD_CAM_EDM_DRO] Re: Gecko question

----- Original Message -----
From: <mariss92705@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Tuesday, March 27, 2001 10:37 PM
Subject: [CAD_CAM_EDM_DRO] Re: Gecko question


> Tom,
>
> I just posted the "WINDOW COMPARATOR.pdf" to the "files" section.
> Hope that was what you wanted.
>
> Mariss
>
>
>
> --- In CAD_CAM_EDM_DRO@y..., "Tom Eldredge" <harmonyt@r...> wrote:
>
> > Also, I heard that you contributed a circuit which could be used to
> control
> > torch height of a plasma cutter based on cutting voltage. Is this
> true? I
> > would like to see that schematic, if possible.
> >
> > Tom Eldredge
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>