Re: [CAD_CAM_EDM_DRO] Gecko question
Posted by
Tom Eldredge
on 2001-03-27 07:33:21 UTC
Mariss,
Thank you for your continued support, instruction and interest. A couple of
us have a question for you.
Some encoders draw more than 50 ma. Can't we just use an external power
supply whose ground is tied to your drive signal ground?
Also, I heard that you contributed a circuit which could be used to control
torch height of a plasma cutter based on cutting voltage. Is this true? I
would like to see that schematic, if possible.
Tom Eldredge
Thank you for your continued support, instruction and interest. A couple of
us have a question for you.
Some encoders draw more than 50 ma. Can't we just use an external power
supply whose ground is tied to your drive signal ground?
Also, I heard that you contributed a circuit which could be used to control
torch height of a plasma cutter based on cutting voltage. Is this true? I
would like to see that schematic, if possible.
Tom Eldredge
Discussion Thread
Tom Eldredge
2001-03-27 07:33:21 UTC
Re: [CAD_CAM_EDM_DRO] Gecko question
mariss92705@y...
2001-03-27 11:21:00 UTC
Re: Gecko question
mariss92705@y...
2001-03-27 12:23:49 UTC
Re: Gecko question
mariss92705@y...
2001-03-27 20:53:51 UTC
Re: Gecko question
Tom Eldredge
2001-03-28 07:33:21 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gecko question
pkranger63@y...
2001-11-18 15:20:58 UTC
Gecko question
shymu@b...
2001-11-18 17:36:52 UTC
Re: Gecko question
Alan Marconett KM6VV
2001-11-18 18:18:56 UTC
Re: [CAD_CAM_EDM_DRO] Gecko question
Jon Elson
2001-11-18 21:20:30 UTC
Re: [CAD_CAM_EDM_DRO] Gecko question
Alan Marconett KM6VV
2001-11-19 10:35:30 UTC
Re: [CAD_CAM_EDM_DRO] Gecko question
Al Schoepp
2001-11-20 11:04:22 UTC
Re: [CAD_CAM_EDM_DRO] Gecko question
aspaguy
2002-01-31 19:42:38 UTC
Gecko question
seanc62
2002-01-31 20:28:00 UTC
Re: Gecko question
mariss92705
2002-01-31 20:38:21 UTC
Re: Gecko question
aspaguy
2002-01-31 22:30:46 UTC
Re: Gecko question
mariss92705
2002-01-31 22:37:49 UTC
Re: Gecko question
Dan Mauch
2002-02-01 07:17:11 UTC
RE: [CAD_CAM_EDM_DRO] Gecko question
aspaguy
2002-02-01 17:52:56 UTC
Thanks Mariss Re: Gecko question