CAD CAM EDM DRO - Yahoo Group Archive

Re: Gecko question

on 2001-03-27 12:23:49 UTC
Hi,

Bill Griffin was kind enough to retreive the the circuit and e-mail
it to me. I'll post it to the "files" section.

My apologies to everyone who has tried to contact me at the
mariss92705@... address. I didn't know it even existed as a
mailbox. I just figured that out and will reply to everyone that
wrote. I am not an internet genius; a moron at best perhaps.

Mariss

Discussion Thread

Tom Eldredge 2001-03-27 07:33:21 UTC Re: [CAD_CAM_EDM_DRO] Gecko question mariss92705@y... 2001-03-27 11:21:00 UTC Re: Gecko question mariss92705@y... 2001-03-27 12:23:49 UTC Re: Gecko question mariss92705@y... 2001-03-27 20:53:51 UTC Re: Gecko question Tom Eldredge 2001-03-28 07:33:21 UTC Re: [CAD_CAM_EDM_DRO] Re: Gecko question pkranger63@y... 2001-11-18 15:20:58 UTC Gecko question shymu@b... 2001-11-18 17:36:52 UTC Re: Gecko question Alan Marconett KM6VV 2001-11-18 18:18:56 UTC Re: [CAD_CAM_EDM_DRO] Gecko question Jon Elson 2001-11-18 21:20:30 UTC Re: [CAD_CAM_EDM_DRO] Gecko question Alan Marconett KM6VV 2001-11-19 10:35:30 UTC Re: [CAD_CAM_EDM_DRO] Gecko question Al Schoepp 2001-11-20 11:04:22 UTC Re: [CAD_CAM_EDM_DRO] Gecko question aspaguy 2002-01-31 19:42:38 UTC Gecko question seanc62 2002-01-31 20:28:00 UTC Re: Gecko question mariss92705 2002-01-31 20:38:21 UTC Re: Gecko question aspaguy 2002-01-31 22:30:46 UTC Re: Gecko question mariss92705 2002-01-31 22:37:49 UTC Re: Gecko question Dan Mauch 2002-02-01 07:17:11 UTC RE: [CAD_CAM_EDM_DRO] Gecko question aspaguy 2002-02-01 17:52:56 UTC Thanks Mariss Re: Gecko question