Re: [CAD_CAM_EDM_DRO] stepper wiring

I have an Oatley board at home I built from a kit, I'm assuming you have the same thing.
Email me in a few hours at this address ( joev@... ) and I will look at what I did.
I used mine to build a CNC Etch-a-Sketch
Be aware that at least my Oatley board is phase drive, it won't respond to a step/dir controller.

mabw@... wrote:

> Hi list!
> Can anyone help me with wiring up some old slo/syn steppers,
> they are six wire jobs, the black, red and red/white wires all have
> continuity with each other ( one phase?) white, green and white/green
> wires the same thing(the other phase?). I need to wire them to a
> driver board from Oatley Electronics (anyone used these?) . The board
> has six spots to wire to, starting from the left on the board is
> ground then two spots for mototr b(one phase?) then two spots for
> motor A (the other phase?) then a spot for positive, ok what goes
> where???. Anyone know what I do next ?
> thanks in anticipation!!
> Mark
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/