Re: [CAD_CAM_EDM_DRO] Gecko 5V supply

----- Original Message -----
From: Tim Goldstein <timg@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Tuesday, April 03, 2001 10:58 AM
Subject: RE: [CAD_CAM_EDM_DRO] Gecko 5V supply


> You can take a 9 v or so wall wart and run it through a $1.00 or less
> voltage regulator (7805 would do the trick and you can even get them from
> Rat Shack). You will then have a nice regulated power supply for very
little
> cost.
>
> Tim
> [Denver, CO]
>
> > Gentlemen,
> >
> > Where can you get cheap 5volt wall warts? I see the 4.5 and
> > 6 volt ones all
> > the time, but 5v? They seem to run around $25.00 USD. I can
> > get a used PC
> > power supply for 5-10 USD. And that is a regulated power
> > supply with a
> > chord and power off switch.
> >
> > Tom Eldredge
> >
> > FAQ: http://www.ktmarketing.com/faq.html
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>