Re: Milling Glass

Hi Dave,
I think you have something there! The glass would have to
lay flat. A hypodermic needle in the Z axis. Hmmm. Not bad Dave!
I can see it!
John

--- In CAD_CAM_EDM_DRO@y..., dave engvall <dengvall@e...> wrote:
> kleinbauer@j... wrote:
>
> > Hi Jeff,
> > I was looking to texture the glass and put peoples
> > pictures on the glass. I see people are doing this with
> > rock and glass using diamond bits. I found this to be too
> > slow and costly.
> > I pictured a booth where the glass sits. The spray gun
> > is moved by X Y units outside the booth just like a
> > sandblaster. Have you ever seen a sand blaster? You stay
> > outside while you hands go inside VIA rubber gloves. Just
> > like a dot matrix printer the gun goes back and forth.
> >
> >
> > John
>
> Well you could just dispense tiny dots of NaF/H2sO4 paste, let it
etch and then wash off. <not entirely kidding>
>
> Dave