Re: [CAD_CAM_EDM_DRO] Stuck collet

Try using a brass rod thru the spindle to tap out the tool/collet. That
shouold help prevent damage to the tool.

Smoke

>What is the trick to getting the collet out of the spindle, when you
>are using a doubled-ended end-mill?
>
>If I hit the end of the mill, through the hollow spindle, I am going
>to break a perfectly good mill end.
>
>I also have had a hard time getting the bit out of the collet.
>
>Thanks,
>Buck
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@yahoogroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
>Moderator: jmelson@... timg@... [Moderator]
>URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>bill,
>List Manager
>
>FAQ: http://www.ktmarketing.com/faq.html
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>