Re: [CAD_CAM_EDM_DRO] Stuck collet

----- Original Message -----
From: <yahoo@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: 06 May 2001 06:31
Subject: [CAD_CAM_EDM_DRO] Stuck collet


> What is the trick to getting the collet out of the spindle, when you
> are using a doubled-ended end-mill?
>
> If I hit the end of the mill, through the hollow spindle, I am going
> to break a perfectly good mill end.
>
> I also have had a hard time getting the bit out of the collet.
>
> Thanks,
> Buck
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>