Re: [CAD_CAM_EDM_DRO] U.S. 220 vs Euro 220

These two currents are definitely very different.
In America we have 240 Volts and 60 Hertz frequency
in Europe there is 220V and 50 Hertz.
The 50 Hz motors have much more inertia than the 60 Hz ones.
At least this is the case with threefase and normal singlefase motors.
How it is with DC and step motors I have no clue.

The result is you can easily take a machine from Europe to America.
Only the motors rise 20% in speed and loose 20% in torque.
For contactors you frequently have to step up the voltage
from 220V 20% up to 264 Volt. Otherwise the shatter.
But if you take from America a machine to Europe you will burn it in a
very short time.
because the motors low inertia. In other words the gap between the sinus
curve of voltage
in 50 Hz is too long and the motor for 60 Hz does not come over this
dead point.
If you want to take it with you you probably need a inverter to produce
your own 60 Hz
current.
Hope this is a hint and saves you a loss.
Good Luck
Sven Peter

blueveil@... wrote:

> Does anyone know if U.S. 220 is the same as European 220?
> Could I take a 220 single phase cnc machine to Europe and use
> it without any adapters?
> Any knowledge on this subject would be greatly appreciated.
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

[Non-text portions of this message have been removed]