CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Postprocessor

on 2001-05-17 18:16:51 UTC
Fred Smith wrote:

> I'm going to jump in here and say a word or two about post
> processors. By the way John S., you are TOO kind. Make sure to let
> me know when you want to do some 3D stuff ;-)

Thanks to Bob Campbell, Tim Goldstein, and Fred Smith for their
comments on Post Processors. I'm glad that post processors are
pretty much un-needed now that some advancements have been made
in the past 20 years when I first heard about post processors.
It really makes no sense to me to have a cascade of programs from
drawing to motor driver.

I guess at this point, I'm not sure about the controller
attributes. I guess a controller is essentially an electronic
router that sends the processed G-code to each motor driver. I
assume controller functions can be done by a plug in board in the
computer mother board or by a computer program that outputs thru
the parallel port. I assume from what Fred said that the CAM
functions of Vector do this without any add-on computer board.

In any case, I thank all of you for your replies.

JerryK

Discussion Thread

Jerry Kimberlin 2001-05-13 18:30:04 UTC Postprocessor Bob Campbell 2001-05-13 19:18:09 UTC Re: [CAD_CAM_EDM_DRO] Postprocessor Tim Goldstein 2001-05-13 19:50:02 UTC RE: [CAD_CAM_EDM_DRO] Postprocessor Fred Smith 2001-05-13 21:10:39 UTC Re: Postprocessor Tim Goldstein 2001-05-13 22:36:36 UTC Taper Lock bushed pulleys machines@n... 2001-05-14 00:10:38 UTC Re: Taper Lock bushed pulleys machines@n... 2001-05-14 00:13:41 UTC Re: Postprocessor Smoke 2001-05-14 21:39:49 UTC Re: [CAD_CAM_EDM_DRO] Taper Lock bushed pulleys wanliker@a... 2001-05-14 21:59:32 UTC Re: [CAD_CAM_EDM_DRO] Taper Lock bushed pulleys machines@n... 2001-05-15 00:20:15 UTC Re: Taper Lock bushed pulleys Sven Peter, TAD S.A. 2001-05-15 04:49:39 UTC Re: [CAD_CAM_EDM_DRO] Taper Lock bushed pulleys timg@k... 2001-05-15 12:42:02 UTC Re: Taper Lock bushed pulleys Jerry Kimberlin 2001-05-17 18:16:51 UTC Re: [CAD_CAM_EDM_DRO] Re: Postprocessor Ray 2001-05-18 06:52:27 UTC Re: Re: Re: Postprocessor Jerry Kimberlin 2001-05-18 07:24:50 UTC Re: [CAD_CAM_EDM_DRO] Re: Re: Re: Postprocessor dougrasmussen@c... 2001-05-18 07:29:55 UTC Re: Postprocessor machines@n... 2001-05-18 08:52:01 UTC Re: Re: Postprocessor Alan Marconett KM6VV 2001-05-18 18:39:58 UTC Re: Postprocessor ballendo@y... 2001-05-21 18:34:54 UTC Re: Postprocessor