CAD CAM EDM DRO - Yahoo Group Archive

Re: Taper Lock bushed pulleys

Posted by machines@n...
on 2001-05-15 00:20:15 UTC
--- In CAD_CAM_EDM_DRO@y..., "Smoke" <gordonr@r...> wrote:
> As I recall from my engineering days Tim, taperlock pulleys are
held on the
> tapered hub by means of three or more bolts. Removing these bolts
should
> allow the pulley to slip off the hub very easily. Then (if I
remeber
> correctly) the hub can be removed from the shaft by first removing
some set
> screws.
>
> Hope this helps.
> Smoke
>

See post number 24947 for an true explanation

Discussion Thread

Jerry Kimberlin 2001-05-13 18:30:04 UTC Postprocessor Bob Campbell 2001-05-13 19:18:09 UTC Re: [CAD_CAM_EDM_DRO] Postprocessor Tim Goldstein 2001-05-13 19:50:02 UTC RE: [CAD_CAM_EDM_DRO] Postprocessor Fred Smith 2001-05-13 21:10:39 UTC Re: Postprocessor Tim Goldstein 2001-05-13 22:36:36 UTC Taper Lock bushed pulleys machines@n... 2001-05-14 00:10:38 UTC Re: Taper Lock bushed pulleys machines@n... 2001-05-14 00:13:41 UTC Re: Postprocessor Smoke 2001-05-14 21:39:49 UTC Re: [CAD_CAM_EDM_DRO] Taper Lock bushed pulleys wanliker@a... 2001-05-14 21:59:32 UTC Re: [CAD_CAM_EDM_DRO] Taper Lock bushed pulleys machines@n... 2001-05-15 00:20:15 UTC Re: Taper Lock bushed pulleys Sven Peter, TAD S.A. 2001-05-15 04:49:39 UTC Re: [CAD_CAM_EDM_DRO] Taper Lock bushed pulleys timg@k... 2001-05-15 12:42:02 UTC Re: Taper Lock bushed pulleys Jerry Kimberlin 2001-05-17 18:16:51 UTC Re: [CAD_CAM_EDM_DRO] Re: Postprocessor Ray 2001-05-18 06:52:27 UTC Re: Re: Re: Postprocessor Jerry Kimberlin 2001-05-18 07:24:50 UTC Re: [CAD_CAM_EDM_DRO] Re: Re: Re: Postprocessor dougrasmussen@c... 2001-05-18 07:29:55 UTC Re: Postprocessor machines@n... 2001-05-18 08:52:01 UTC Re: Re: Postprocessor Alan Marconett KM6VV 2001-05-18 18:39:58 UTC Re: Postprocessor ballendo@y... 2001-05-21 18:34:54 UTC Re: Postprocessor