Re: Taper Lock bushed pulleys

Yes, mine match your desciption exactly. Will try running the grub
screw into the middle hole.

Tim
[Denver, CO]

> Tim
> These are very simple. You should have two allen grub screws

holding

> it on roughly 180 degrees apart. Remove them both and replace one

in

> the hole between the two you have just took out. Tighten this one

and

> it will self extract. That's all there is to it. Refitting is just
> placing it in position and replacing the two original screws in the
> 180 degree holes.
> If you examine the pulley and hub you will see that they are

tapped

> opposite for this to work.