CAD CAM EDM DRO - Yahoo Group Archive

Re: Re: Re: Postprocessor

Posted by Ray
on 2001-05-18 06:52:27 UTC
From: Jerry Kimberlin <kimberln@...>
<s>
>I assume from what Fred said that the CAM
>functions of Vector do this without any add-on computer board.

Good question, good area for discussion, but bad assumption.;)

What the cam functions in Vector do is allow you to select the path taken
by the tool around the drawing in the cad portion of Vector and add speed,
feed, and aux IO info and put out a G-code program that can be read by
dedicated g-code driven motion boards or other motion software. Vector
does not directly run motors.

Ray

Discussion Thread

Jerry Kimberlin 2001-05-13 18:30:04 UTC Postprocessor Bob Campbell 2001-05-13 19:18:09 UTC Re: [CAD_CAM_EDM_DRO] Postprocessor Tim Goldstein 2001-05-13 19:50:02 UTC RE: [CAD_CAM_EDM_DRO] Postprocessor Fred Smith 2001-05-13 21:10:39 UTC Re: Postprocessor Tim Goldstein 2001-05-13 22:36:36 UTC Taper Lock bushed pulleys machines@n... 2001-05-14 00:10:38 UTC Re: Taper Lock bushed pulleys machines@n... 2001-05-14 00:13:41 UTC Re: Postprocessor Smoke 2001-05-14 21:39:49 UTC Re: [CAD_CAM_EDM_DRO] Taper Lock bushed pulleys wanliker@a... 2001-05-14 21:59:32 UTC Re: [CAD_CAM_EDM_DRO] Taper Lock bushed pulleys machines@n... 2001-05-15 00:20:15 UTC Re: Taper Lock bushed pulleys Sven Peter, TAD S.A. 2001-05-15 04:49:39 UTC Re: [CAD_CAM_EDM_DRO] Taper Lock bushed pulleys timg@k... 2001-05-15 12:42:02 UTC Re: Taper Lock bushed pulleys Jerry Kimberlin 2001-05-17 18:16:51 UTC Re: [CAD_CAM_EDM_DRO] Re: Postprocessor Ray 2001-05-18 06:52:27 UTC Re: Re: Re: Postprocessor Jerry Kimberlin 2001-05-18 07:24:50 UTC Re: [CAD_CAM_EDM_DRO] Re: Re: Re: Postprocessor dougrasmussen@c... 2001-05-18 07:29:55 UTC Re: Postprocessor machines@n... 2001-05-18 08:52:01 UTC Re: Re: Postprocessor Alan Marconett KM6VV 2001-05-18 18:39:58 UTC Re: Postprocessor ballendo@y... 2001-05-21 18:34:54 UTC Re: Postprocessor