Re: [CAD_CAM_EDM_DRO] Taper Lock bushed pulleys

Often these taper lock pulleys have on the rim threads where you have to thread in
the set screws and push the taper out. These things stick sometimes extremly hard.
So be shure that the tip of the screws are a little tapered., otherwise the squeze up.
Good Luck
Sven Peter

Smoke wrote:

> As I recall from my engineering days Tim, taperlock pulleys are held on the
> tapered hub by means of three or more bolts. Removing these bolts should
> allow the pulley to slip off the hub very easily. Then (if I remeber
> correctly) the hub can be removed from the shaft by first removing some set
> screws.
>
> Hope this helps.
> Smoke
>
> >I am wanting to pull the L series timing pulley off of one of Bridgett's
> >steppers and it is attached with a Taper Lock bush on the pulley. Anyone
> >know how to remove this type of pulley without damaging the pulley or the
> >motor?
> >
> >Tim
> >[Denver, CO]
> >
> >
> >Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
> discussion of shop built systems, for CAD, CAM, EDM, and DRO.
> >
> >Addresses:
> >Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> >Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> >Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> >List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> >Moderator: jmelson@... timg@... [Moderator]
> >URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> >bill,
> >List Manager
> >
> >FAQ: http://www.ktmarketing.com/faq.html
> >
> >Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
> >
> >
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

[Non-text portions of this message have been removed]