Re: using a CNC mill to engrave metal

I think that I'm using the Taig 2019CR leadscrew but I only have the
2018 table, I don't have any problems with this set up, but I doubt
that you'd very easily get a longer leascrew for your 2019CR.

Rab

--- In CAD_CAM_EDM_DRO@y..., ym_wong@p... wrote:
> --- In CAD_CAM_EDM_DRO@y..., rab@r... wrote:
> > I converted the mill from manual to cnc using parts from Taig,
but
> > the X leadscrew was meant for a model with a longer table.
> > I also put a 2" spacer block between the Z column and the mill
base.
> >
> > Rab
>
> I have a 12-in travel version, the 2019CR, but would be very
> interested in have a few more inches of travel on the x-axis. With
> that long screw, did you have any problem using the left side of
the
> base?
>
> Regards,
> ym