Re: [CAD_CAM_EDM_DRO] Re: using a CNC mill to engrave metal

Hi
how was the total cost on driver board motors and ball scrrew assambly??

shabbir

At 09:43 AM 8/17/01 +0000, you wrote:

>I converted the mill from manual to cnc using parts from Taig, but
>the X leadscrew was meant for a model with a longer table.
>I also put a 2" spacer block between the Z column and the mill base.
>
>Rab
>
>>
>> Thanks. I notice in that picture your x-axis leadscrew was sticking
>> out a fair bit. Besides putting in a longer one, did you modify the
>> mechanism in any other way? Just curious.
>>
>> Regards,
>> ym
>
>
>Addresses:
>FAQ: http://www.ktmarketing.com/faq.html
>FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
>Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
>Moderator: jmelson@... timg@... [Moderator]
>URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>bill,
>List Manager
>
>
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>