Re: [CAD_CAM_EDM_DRO] Re: Tool up

Where can you get new 40 int collet chucks for £35? I am obviously looking
in the wrong places!

I am interested in the ball screws. Could you let me know how much you want
for them?

Thanks,
Les

les@...


John,
Here's a picture of a Beaver BVRP
http://www.zhongyang-engrg.com/catalog/me9954.htm
They are 10" x 48" table machines with a 40 Int spindle taper. Same
build up as a Bridgeport but a *lot* stronger. Motor is usually 4 or
5 Hp 440v 3 phase, but I have seen these with 3Hp single phase fitted.
Brand new ER32 collet chucks cost 35 pounds each at the moment.
Somewhere kicking about I have a box of 20 plus pieces of 40 int
tooling that's going spare. Most have closer nuts missing and there
are only a few collets.
I even have spare X and Y axis ball screws for one of these with the
motor mounts and bearings.
Although some one was interestd in the Y axis screw.

John Stevenson