RE: [CAD_CAM_EDM_DRO] Re: Looking for a servo amplifier.....

Never mind the cost of sending something to Kollmorgen. You'd have to sell
and kid or two. The phone estimate was in the $2,000 to $3,000 range.

Here is the link for repair manuals that I used:

http://kmtg.kollmorgen.com/products/product_literature/technical_documen
tation/mature_docs.html#Obsolete

I hope it helps someone else out.

Ethan


-----Original Message-----
From: Jon Elson [SMTP:elson@...]
Sent: Friday, November 16, 2001 2:48 PM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: Re: [CAD_CAM_EDM_DRO] Re: Looking for a servo amplifier.....

Ethan Vos wrote:

> I agree about the CNC techs. We just fixed a big 4 axis horizontal

machine

> that would not come out of e-stop. We tracked it down to a servo drive

and

> Kollmorgen suggested that we send it in for repair. I can only imagine

what

> that would have cost.
>
> Turns out that the drive schematic is on the internet and it took us a

day

> to find the blown capacitor. Less than $2.00 to get things running again.

+1 day of work - but still, you are up and running a LOT faster than if you
had to ship the drive module out for repair.

Where are these schematics located on the net? I'd sure like to know about
that!

Jon


Addresses:
FAQ: http://www.ktmarketing.com/faq.html
FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/

Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
Moderator: jmelson@... timg@... [Moderator]
URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
bill,
List Manager



Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/