CAD CAM EDM DRO - Yahoo Group Archive

Re: gecko wiring help

on 2001-12-13 06:30:21 UTC
Try reversing one coil connection on the motor. If the motors are
connected with one coil in reverse of the other no damage will be
done as the coils are not shorted together, but the motor will not
turn either.

Tim
[Denver, CO]

--- In CAD_CAM_EDM_DRO@y..., "pkranger63" <pkranger63@y...> wrote:
> Well I gotta be close to getting this thing to work. Like I said I
> get a voltage change when I hook my DVM to the step and dir
terminals
> and I use "jog". I can get this voltage change with both Turbocnc
and
> Master5. I also get the holding torque you talk about when the
power
> supply is turned on. I just cant get the motor to move. What else
> should I be checking. I have checked and re-checked my pins on my
> parrallel port. I am encouraged by what I have done so far and
feel
> I am close to getting this thing to work. As always thanks!
>
> Matt

Discussion Thread

pkranger63 2001-12-11 18:11:18 UTC gecko wiring help Alan Marconett KM6VV 2001-12-11 20:12:13 UTC Re: [CAD_CAM_EDM_DRO] gecko wiring help pkranger63 2001-12-11 21:00:02 UTC Re: gecko wiring help Carol & Jerry Jankura 2001-12-11 21:25:09 UTC RE: [CAD_CAM_EDM_DRO] Re: gecko wiring help Dennis Cranston 2001-12-12 07:17:17 UTC RE: [CAD_CAM_EDM_DRO] Re: gecko wiring help Alan Marconett KM6VV 2001-12-12 10:31:45 UTC Re: gecko wiring help Alan Marconett KM6VV 2001-12-12 11:10:32 UTC Re: gecko wiring help pkranger63 2001-12-12 21:04:46 UTC Re: gecko wiring help tgoldsteinsprint1 2001-12-13 06:30:21 UTC Re: gecko wiring help pkranger63 2001-12-13 06:59:19 UTC Re: gecko wiring help tgoldsteinsprint1 2001-12-13 07:50:25 UTC Re: gecko wiring help Alan Marconett KM6VV 2001-12-13 13:00:42 UTC Re: gecko wiring help Alan Marconett KM6VV 2001-12-13 13:33:20 UTC Re: gecko wiring help pkranger63 2001-12-13 20:08:18 UTC Re: gecko wiring help Alan Marconett KM6VV 2001-12-13 20:20:04 UTC Re: gecko wiring help Alex Canale 2001-12-14 05:26:18 UTC RE: [CAD_CAM_EDM_DRO] I am not selling CNC knee mills! tgoldsteinsprint1 2001-12-14 06:34:41 UTC Re: gecko wiring help Dan Mauch 2001-12-14 07:41:31 UTC Gecko 201/G320 common signal GROUND! wanliker@a... 2002-01-06 14:22:43 UTC Re: [CAD_CAM_EDM_DRO] Gecko 201/G320 common signal GROUND! Dan Mauch 2002-01-07 09:41:36 UTC RE: [CAD_CAM_EDM_DRO] Gecko 201/G320 common signal GROUND!