Re: G201 Question for Mariss

I want to disable them to allow me to use the mill manually. My
motors have dual shafts and I installed the original hand wheels on
the rear shafts. Even if the drives are powered down the motors
generate enough back EMF to make it hard to turn them. I am assuming
that the disable state has the motor coils in an open circuit.

--- In CAD_CAM_EDM_DRO@y..., "RC" <asdf@c...> wrote:
> What was you going use the "disable" mode for? If it's for an
emergency
> type panic button, then connecting all make sense, how else would
one stop
> motion on all three quickly? I though about using two
configurations, one
> for a "Z" drive only, to free up that drive to make tool changes,
and the
> other as all three at once for an emergency stop.
>
> Russ
> ----- Original Message -----
> From: rsgoldner <rgoldner@i...>
> To: <CAD_CAM_EDM_DRO@y...>
> Sent: Friday, April 05, 2002 4:38 PM
> Subject: [CAD_CAM_EDM_DRO] G201 Question for Mariss
>
>
> > I have three G201s. Can I connect all three aux gnd pins (pin
12) to
> > one side of a switch and all three disable pins to the other
side of
> > a switch? The idea is to disable all three motors with one
switch.
> > Is aux gnd the same as the power supply gnd and could I just
connect
> > all the disable pins to the PS gnd through the switch instead?
> >
> > Thanks!
> >
> >
> > Addresses:
> > FAQ: http://www.ktmarketing.com/faq.html
> > FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> >
> > OFF Topic POSTS: General Machining
> > If you wish to post on unlimited OT subjects goto:
> aol://5863:126/rec.crafts.metalworking or go thru Google.com to
reach it if
> you have trouble.
> > http://www.metalworking.com/news_servers.html
> >
> > http://groups.yahoo.com/group/jobshophomeshop I consider this
as a
> sister site to the CCED group, as many of the same memembers are
there, for
> OT subjects, that are not allowed on the CCED list.
> >
> >
> >
> > Post messages: CAD_CAM_EDM_DRO@y...
> > Subscribe: CAD_CAM_EDM_DRO-subscribe@y...
> > Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@y...
> > List owner: CAD_CAM_EDM_DRO-owner@y..., wanliker@a...
> > Moderator: jmelson@a... timg@k... [Moderator]
> > URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> > bill,
> > List Mom
> > List Owner
> >
> >
> >
> > Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/
> >
> >