CAD CAM EDM DRO - Yahoo Group Archive

Re: G201 Question for Mariss

Posted by mariss92705
on 2002-04-17 22:29:27 UTC
Hi,

A prinded circuit board with a whole lot of stuff on it that works is
worth a whole lot more than a salvaged component. Especially if it
comes with a plated-thru hole sleeve with it as an extra bonus.

Mariss

--- In CAD_CAM_EDM_DRO@y..., JanRwl@A... wrote:
> In a message dated 17-Apr-02 06:52:47 Central Daylight Time,
> umrk@b... writes:
>
>
> > I had already decided to sacrifice the Opto and pin for pin
desolder
> > to minimize the possibility of damage to the board.
>
>
> Best choice, if you are careful and reasonably skilled at
such! "Salvaging"
> a $0.89 IC is NEVER worth all the hassle to "IC-desolder"!!!
>
>
> [Non-text portions of this message have been removed]

Discussion Thread

rsgoldner 2002-04-05 16:38:46 UTC G201 Question for Mariss mariss92705 2002-04-05 17:11:47 UTC Re: G201 Question for Mariss Raymond Heckert 2002-04-05 20:25:45 UTC Re: [CAD_CAM_EDM_DRO] G201 Question for Mariss rsgoldner 2002-04-06 03:08:34 UTC Re: G201 Question for Mariss RC 2002-04-06 03:24:04 UTC Re: [CAD_CAM_EDM_DRO] G201 Question for Mariss rsgoldner 2002-04-06 06:37:40 UTC Re: G201 Question for Mariss RC 2002-04-06 06:59:50 UTC Re: [CAD_CAM_EDM_DRO] Re: G201 Question for Mariss batwings@i... 2002-04-06 14:23:42 UTC Re: [CAD_CAM_EDM_DRO] Re: G201 Question for Mariss n4onl 2002-04-15 19:52:46 UTC G201 Question for Mariss mariss92705 2002-04-15 21:33:16 UTC Re: G201 Question for Mariss n4onl 2002-04-16 20:39:24 UTC Re: G201 Question for Mariss n4onl 2002-04-17 04:50:18 UTC Re: G201 Question for Mariss cadcamcenter 2002-04-17 05:12:17 UTC Re: G201 Question for Mariss JanRwl@A... 2002-04-17 20:56:58 UTC Re: [CAD_CAM_EDM_DRO] Re: G201 Question for Mariss mariss92705 2002-04-17 22:29:27 UTC Re: G201 Question for Mariss