Re: [CAD_CAM_EDM_DRO] 8 wire steppers, parallel. series or single winding?
Posted by
Jon Elson
on 2002-04-12 22:43:38 UTC
"j.guenther" wrote:
low current and lots of winding inductance really limits the top speed of
the motors. 1.8 V at 1.5 A would be a better motor combination, for
example (more current, lower voltage).
Jon
> Jon,I should also mention that that combination, .5A at 5.5 V is a bad combination,
>
> The machine is a Sherline 5400, 20TPI lead screws direct drive. The current
> reliable top speed is 13.4 IPM. The motors are 80oz/in Pacific Scientific
> motors, rated at .52 amps and IIRC 5.47 volts per phase.
low current and lots of winding inductance really limits the top speed of
the motors. 1.8 V at 1.5 A would be a better motor combination, for
example (more current, lower voltage).
Jon
Discussion Thread
John Guenther
2002-04-12 05:27:30 UTC
8 wire steppers, parallel. series or single winding?
Bob Campbell
2002-04-12 07:19:00 UTC
RE: [CAD_CAM_EDM_DRO] 8 wire steppers, parallel. series or single winding?
j.guenther
2002-04-12 08:00:53 UTC
RE: [CAD_CAM_EDM_DRO] 8 wire steppers, parallel. series or single winding?
studleylee
2002-04-12 09:24:18 UTC
Re: 8 wire steppers, parallel. series or single winding?
stephen_stallings
2002-04-12 10:33:02 UTC
Re: 8 wire steppers, parallel. series or single winding?
Jon Elson
2002-04-12 11:03:00 UTC
Re: [CAD_CAM_EDM_DRO] 8 wire steppers, parallel. series or single winding?
j.guenther
2002-04-12 11:24:46 UTC
RE: [CAD_CAM_EDM_DRO] 8 wire steppers, parallel. series or single winding?
Tim Goldstein
2002-04-12 12:12:42 UTC
Re: [CAD_CAM_EDM_DRO] 8 wire steppers, parallel. series or single winding?
mariss92705
2002-04-12 14:06:46 UTC
Re: 8 wire steppers, parallel. series or single winding?
JanRwl@A...
2002-04-12 21:41:57 UTC
Re: [CAD_CAM_EDM_DRO] 8 wire steppers, parallel. series or single winding?
Jon Elson
2002-04-12 22:39:50 UTC
Re: [CAD_CAM_EDM_DRO] 8 wire steppers, parallel. series or single winding?
Jon Elson
2002-04-12 22:43:38 UTC
Re: [CAD_CAM_EDM_DRO] 8 wire steppers, parallel. series or single winding?
Carol & Jerry Jankura
2002-04-13 05:57:22 UTC
RE: [CAD_CAM_EDM_DRO] 8 wire steppers, parallel. series or single winding?