re:Re: Anti-backlash on Taig mill was:Re: Digest Number 2309
Posted by
Elliot Burke
on 2002-05-13 10:50:22 UTC
Steve Blackmore writes:
is supported at the motor end, not at the end opposite the motor.
Where are the tensioning screws you mention and the ballrace?
Elliot Burke
>The ends of the screws have a ballrace which is tensioned by theI have a Taig mill, it has 1/2-20 leadscrews and a brass(?) nut. The screw
>endnut - this removes the backlash - isn't this good enough for you?
is supported at the motor end, not at the end opposite the motor.
Where are the tensioning screws you mention and the ballrace?
Elliot Burke
Discussion Thread
Andrew Werby
2002-05-12 19:54:34 UTC
Re: [CAD_CAM_EDM_DRO] Digest Number 2309
thosmurray
2002-05-12 23:06:23 UTC
Anti-backlash on Taig mill was:Re: Digest Number 2309
Peter Homann
2002-05-13 00:27:22 UTC
Using a CNC Mill to tap holes?
Steve Blackmore
2002-05-13 00:54:37 UTC
Re: [CAD_CAM_EDM_DRO] Anti-backlash on Taig mill was:Re: Digest Number 2309
Marcus & Eva
2002-05-13 08:11:06 UTC
Re: [CAD_CAM_EDM_DRO] Using a CNC Mill to tap holes?
bjammin@i...
2002-05-13 08:16:58 UTC
Re: [CAD_CAM_EDM_DRO] Using a CNC Mill to tap holes?
Elliot Burke
2002-05-13 10:50:22 UTC
re:Re: Anti-backlash on Taig mill was:Re: Digest Number 2309
Steve Blackmore
2002-05-13 12:28:37 UTC
Re: [CAD_CAM_EDM_DRO] re:Re: Anti-backlash on Taig mill was:Re: Digest Number 2309
JanRwl@A...
2002-05-13 14:45:59 UTC
Re: [CAD_CAM_EDM_DRO] Using a CNC Mill to tap holes?
Jon Elson
2002-05-13 22:20:31 UTC
Re: [CAD_CAM_EDM_DRO] Using a CNC Mill to tap holes?
bjammin@i...
2002-05-14 03:48:59 UTC
Anti-backlash on Taig mill
Steve Blackmore
2002-05-14 05:24:39 UTC
Re: [CAD_CAM_EDM_DRO] Anti-backlash on Taig mill
tonyjeffree
2002-05-14 11:26:45 UTC
Re: Anti-backlash on Taig mill
Andrew Werby
2002-05-14 11:49:01 UTC
Anti-backlash on Taig mill