Re: [CAD_CAM_EDM_DRO] re:Re: Anti-backlash on Taig mill was:Re: Digest Number 2309

On Mon, 13 May 2002 10:51:54 -0700, you wrote:

>Steve Blackmore writes:
>>The ends of the screws have a ballrace which is tensioned by the
>>endnut - this removes the backlash - isn't this good enough for you?
>
>I have a Taig mill, it has 1/2-20 leadscrews and a brass(?) nut. The screw
>is supported at the motor end, not at the end opposite the motor.
>
>Where are the tensioning screws you mention and the ballrace?

They are not tensioning screws??? - remove the motor and motor
mounting tube, adjust preload by tightening/loosening the 1/2" nylock
end nut.

Steve Blackmore
--
Pilot Consultancy Limited ***** Computer Consultants
Telephone 01744 752256 Mobile 07831 768478
Email: steve@... WWW: http://www.pilotltd.net