Re: DRO Boards

Dan,

Thanks for the reply. I looked carefully and I don't see
any "instructions" on your recent message. Am I missing something?

Sincerely yours,
Mac

--- In CAD_CAM_EDM_DRO@y..., "Dan Mauch" <dmauch@s...> wrote:
> The plans don't include the pcb layout but here are the
instructions.
> Dan
> -----Original Message-----
> From: macfool68 [mailto:gr8flyer7@h...]
> Sent: Tuesday, November 12, 2002 4:46 PM
> To: CAD_CAM_EDM_DRO@y...
> Subject: [CAD_CAM_EDM_DRO] Re: DRO Boards
>
>
> --- In CAD_CAM_EDM_DRO@y..., "Dan Mauch" <dmauch@s...> wrote:
> >
> > I am considering discontinuing the Mauch/Kulaga DRO printed
circuit
> > board for two reasons. Sales have been slow. Only 35 in 1 year
and
> it
> > was made for a rapidly disappearing ISA slot.
> > I have one good board and 3 defective boards left. After the good
> board
> > is sold I doubt that I will reorder them unless there is more
> interest
> > in them.
> > Dan
>
>
> I am interested in the Mauch/Kulaga DRO printed circuit board 3/4
> axis kit if you have one available. If not, I am still interested
> in getting the plans, if you still sell those instead?
>
> Thank you in advance,
> Mac
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@y...