RE: [CAD_CAM_EDM_DRO] Re: DRO Boards

Hi Dan
A friend asked me recently whether he can cnc his Collet mill that is
already fitted with a dro system and drive motors. I don't know much about
DRO's so excuse me for asking stupid questions.

Currently you can move the axis' on the mill with a switch forward and back
and read the position from the DRO. Would it be possible to hook this DRO up
to a computer somehow that runs something like Turbocnc? If possible, what
are the steps needed? Is that perhaps what your DRO boards do?

Thanks
Coert

-----Original Message-----
From: macfool68 [mailto:gr8flyer7@...]

--- In CAD_CAM_EDM_DRO@y..., "Dan Mauch" <dmauch@s...> wrote:
>
> I am considering discontinuing the Mauch/Kulaga DRO printed circuit
> board for two reasons. Sales have been slow. Only 35 in 1 year and
it
> was made for a rapidly disappearing ISA slot.
> I have one good board and 3 defective boards left. After the good
board
> is sold I doubt that I will reorder them unless there is more
interest
> in them.
> Dan


Confidentiality Warning
=======================
The contents of this e-mail and any accompanying documentation
are confidential and any use thereof, in what ever form, by anyone
other than the addressee is strictly prohibited.