Re: [CAD_CAM_EDM_DRO] Re: DRO Boards

Dan,

Would you be willing to make the board files available on an "open sources"
basis? That way if someone wants one they can either have a board made as a
prototype or use one of the programs like DeskPCB to make the G-code to
route one out.

If you are willing I would be happy to add it to the Kulaga DRO site I host.

Tim
[Denver CO]
Sherline at Deep Discount
www.KTMarketing.com/Sherline

----- Original Message -----
> The DRO boards are all sold and like I said there wasn't enough sales to
> justify and outlay of $500 for more boards so the point is moot.
> But with deskncrt it was possible to shut off the power to the stepper
> motors and read the encoder positions like a dro. As I recall EMC will
> also do this.
> If you are running a stepper system using turbocnc and your system is
> running correctly then you don't need a dro.
> dan