CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] Questions

on 2002-12-16 09:49:21 UTC
> From: Jon Elson [mailto:elson@...]
>
> alex wrote:
>
> >Larry,
> >what is a source for PM DC motors?
> >
> >
> Herbach & Rademan http://www.herbach.com/
>
> C & H Sales http://aaaim.com/CandH/
>
> Surplus Center, Lincoln NE
> 800-488-3407, 402-474-4055, FAX 877-474-5198 (6/02)
>
> There are others, such as Marlin P Jones, Mendelson, Brigar,
> etc. But, the
> first 3 are the outfits that carry the largest selection of motors.
>
> Jon

I just learned that Surplus Center, Lincoln NE now has a web site at:

http://www.surplussales.com/

Cheers,

Chuck Hackett
"Good judgment comes from experience, experience comes from bad judgment"
7.5" gauge Union Pacific Northern (4-8-4) 844
Railroad: Camp Creek Railroaders, Waverly, Nebraska, USA (3000', 7.5")
Home: Elkhorn, Nebraska (just west of Omaha)

Discussion Thread

Darrell Gehlsen 1999-09-28 10:11:11 UTC Questions Jon Elson 1999-09-28 22:22:02 UTC Re: Questions Jon Elson 2001-01-28 23:02:45 UTC Re: [CAD_CAM_EDM_DRO] Questions James Owens 2001-01-30 07:22:32 UTC Re: [CAD_CAM_EDM_DRO] Questions Yesamazza@a... 2002-12-15 07:27:55 UTC Questions edward c heil jr <eheil@s... 2002-12-15 09:59:58 UTC Re: Questions Russ Waters 2002-12-15 12:55:23 UTC Re: [CAD_CAM_EDM_DRO] Questions Larry Edington 2002-12-15 15:01:50 UTC Re: [CAD_CAM_EDM_DRO] Questions alex 2002-12-16 07:35:54 UTC Re: [CAD_CAM_EDM_DRO] Questions Jon Elson 2002-12-16 09:29:21 UTC Re: [CAD_CAM_EDM_DRO] Questions alex 2002-12-16 09:49:01 UTC Re: [CAD_CAM_EDM_DRO] Questions Egroupscdh (E-mail) 2002-12-16 09:49:21 UTC RE: [CAD_CAM_EDM_DRO] Questions Tim Goldstein 2002-12-16 10:58:00 UTC Re: [CAD_CAM_EDM_DRO] Questions Larry Edington 2002-12-16 19:04:15 UTC Re: [CAD_CAM_EDM_DRO] Questions Egroupscdh (E-mail) 2002-12-16 19:29:57 UTC RE: [CAD_CAM_EDM_DRO] Questions Jon Elson 2002-12-16 23:05:46 UTC Re: [CAD_CAM_EDM_DRO] Questions Jon Elson 2002-12-16 23:11:39 UTC Re: [CAD_CAM_EDM_DRO] Questions alex 2002-12-17 07:04:40 UTC Re: [CAD_CAM_EDM_DRO] Questions