CAD CAM EDM DRO - Yahoo Group Archive

Questions

on 1999-09-28 10:11:11 UTC
I am still working at getting EMC working on my computer and having some
success at last.
If I had it connected to a mill I could probably answer this my self but I'm
not there yet.
The question is when running EMC controling steppers do the axes ramp all
the way down between each block of code on a feed move or is there a way
that you can command the control to not ramp down in the case of say a
linear move followed by a tangent arc followed by another linear move?
Bridgeport had a Deceleration Override non modal G code to do this.
My other question is can I download the archives from this group so I can
read off line?
Darrell

Discussion Thread

Darrell Gehlsen 1999-09-28 10:11:11 UTC Questions Jon Elson 1999-09-28 22:22:02 UTC Re: Questions Jon Elson 2001-01-28 23:02:45 UTC Re: [CAD_CAM_EDM_DRO] Questions James Owens 2001-01-30 07:22:32 UTC Re: [CAD_CAM_EDM_DRO] Questions Yesamazza@a... 2002-12-15 07:27:55 UTC Questions edward c heil jr <eheil@s... 2002-12-15 09:59:58 UTC Re: Questions Russ Waters 2002-12-15 12:55:23 UTC Re: [CAD_CAM_EDM_DRO] Questions Larry Edington 2002-12-15 15:01:50 UTC Re: [CAD_CAM_EDM_DRO] Questions alex 2002-12-16 07:35:54 UTC Re: [CAD_CAM_EDM_DRO] Questions Jon Elson 2002-12-16 09:29:21 UTC Re: [CAD_CAM_EDM_DRO] Questions alex 2002-12-16 09:49:01 UTC Re: [CAD_CAM_EDM_DRO] Questions Egroupscdh (E-mail) 2002-12-16 09:49:21 UTC RE: [CAD_CAM_EDM_DRO] Questions Tim Goldstein 2002-12-16 10:58:00 UTC Re: [CAD_CAM_EDM_DRO] Questions Larry Edington 2002-12-16 19:04:15 UTC Re: [CAD_CAM_EDM_DRO] Questions Egroupscdh (E-mail) 2002-12-16 19:29:57 UTC RE: [CAD_CAM_EDM_DRO] Questions Jon Elson 2002-12-16 23:05:46 UTC Re: [CAD_CAM_EDM_DRO] Questions Jon Elson 2002-12-16 23:11:39 UTC Re: [CAD_CAM_EDM_DRO] Questions alex 2002-12-17 07:04:40 UTC Re: [CAD_CAM_EDM_DRO] Questions