Re: Harbor Freight Micro Mill 47158
Posted by
Randy Gordon-Gilmore
on 2003-02-11 15:28:56 UTC
At 10:24 PM 2/11/2003 -0000, mario wrote:
travel. The table will be halfway off the X ways at each end of its full
travel. Maybe not a problem, but I'd watch it carefully.
Best regards,
Randy
Randy Gordon-Gilmore ,----.___________ ______________ _________________
ProtoTrains // = = === == || == == == = || == == == = == =|
Rio Vista, CA, USA /-O==O------------o==o------------o==o-----------o==o-'
zephyrus@... http://www.prototrains.com
>Maximun X Travel: 9"[snip]
>Table Size: 9-3/8"x5-3/8"This makes me think...the table length is only 3/8" longer than the quoted
travel. The table will be halfway off the X ways at each end of its full
travel. Maybe not a problem, but I'd watch it carefully.
Best regards,
Randy
Randy Gordon-Gilmore ,----.___________ ______________ _________________
ProtoTrains // = = === == || == == == = || == == == = == =|
Rio Vista, CA, USA /-O==O------------o==o------------o==o-----------o==o-'
zephyrus@... http://www.prototrains.com
Discussion Thread
miadsgns <MIADSGNS@a...
2003-02-11 12:21:43 UTC
Harbor Freight Micro Mill 47158
j.guenther
2003-02-11 13:01:01 UTC
RE: [CAD_CAM_EDM_DRO] Harbor Freight Micro Mill 47158
miadsgns <MIADSGNS@a...
2003-02-11 14:24:44 UTC
Re: Harbor Freight Micro Mill 47158
Randy Gordon-Gilmore
2003-02-11 15:28:56 UTC
Re: Harbor Freight Micro Mill 47158
ballendo <ballendo@y...
2003-02-12 08:02:37 UTC
Re: Harbor Freight Micro Mill 47158
miadsgns <MIADSGNS@a...
2003-02-12 10:07:56 UTC
Re: Harbor Freight Micro Mill 47158
turbulatordude <davemucha@j...
2003-02-12 19:14:27 UTC
Re: Harbor Freight Micro Mill 47158
miadsgns <MIADSGNS@a...
2003-02-13 11:34:37 UTC
Re: Harbor Freight Micro Mill 47158
Randy Gordon-Gilmore
2003-02-13 13:40:01 UTC
Re: Harbor Freight Micro Mill 47158
Randy Gordon-Gilmore
2003-02-13 13:48:09 UTC
Re: Harbor Freight Micro Mill 47158
Jack Sullivan
2003-02-13 13:51:13 UTC
Re: [CAD_CAM_EDM_DRO] Re: Harbor Freight Micro Mill 47158
ballendo <ballendo@y...
2003-02-16 16:59:52 UTC
Re: Harbor Freight Micro Mill 47158