CAD CAM EDM DRO - Yahoo Group Archive

Rotary table for CNC mill

on 2003-04-30 09:36:36 UTC
I recently purchased a rotary table with the intention of
prototyping rings. I have made several unsuccessful attempts at
cutting a ring.

The table will cut the ring the full 360 degrees. There is a slight
gap on the bottom portion. Is there anyone who can offer some
information in using the rotary table successfully?

I have made several adjustments as far as increasing the
circumference of the design in the 2D drawing. The problem is if I
increase the cir. the ring size will be altered.


Americo

Discussion Thread

los_pachecos2002 2003-04-30 09:36:36 UTC Rotary table for CNC mill turbulatordude 2003-04-30 11:16:23 UTC Re: Rotary table for CNC mill Raymond Heckert 2003-04-30 20:25:05 UTC Re: [CAD_CAM_EDM_DRO] Rotary table for CNC mill americo pacheco 2003-05-01 15:18:07 UTC Re: [CAD_CAM_EDM_DRO] Rotary table for CNC mill Don McLane 2003-05-10 18:44:45 UTC Mill recommendation Jon Anderson 2003-05-10 19:23:45 UTC Re: [CAD_CAM_EDM_DRO] Mill recommendation Jon Elson 2003-05-10 22:16:25 UTC Re: [CAD_CAM_EDM_DRO] Mill recommendation dvideohd 2003-05-11 00:10:55 UTC Re: Mill recommendation Tim Goldstein 2003-05-11 10:29:15 UTC RE: [CAD_CAM_EDM_DRO] Mill recommendation kdoney_63021 2003-05-11 12:20:26 UTC Re: Mill recommendation David A. Frantz 2003-05-12 00:43:48 UTC Re: [CAD_CAM_EDM_DRO] Mill recommendation