bitscope Was: oscilloscope for CNC

Tanya,
Check out http://racket.bitscope.net/
-Lee


--- In CAD_CAM_EDM_DRO@yahoogroups.com, "tanyasapa" <tanyasapa@y...>
wrote:

> Thanks to all who provided so much info and tips on and off list.
> Did'nt expect to get so much material to digest.
>
> For now, I think I'll just use the PC-based oscilloscope, and put

off

> getting a professional oscilloscope till I get more professional.
>
> Thanks again.
>
> Tanya
>
>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, Stephan Kotzé

<stephank@c...>

> wrote:
> > Tanya
> >
> > If it is analogue signals, you need a bandwidth of about 5 times
> your max frequency you want to measure. Digital signals you need
> about 2 times unless you want to do glitch capture. Something that
> can do a waveform capture is always good. Personally I prefer
> HP/Agilent, but I have a Tektronix scope DSP360 ($4000) . The FLUKE
> Scopemeter series is not to bad if you want portable and rugged.

Stay

> away from anything less than 50 Mhz. Look on Ebay, there is

normally

> a lot of units available.
> >
> > Stephan
> >
> >
> > ---
> > Outgoing mail is certified Virus Free.
> > Checked by AVG anti-virus system (http://www.grisoft.com).
> > Version: 6.0.490 / Virus Database: 289 - Release Date: 18/06/2003
> >
> > [Non-text portions of this message have been removed]